Ham radio antenna patch panel11/14/2022 ![]() ![]() My desk was a jungle, and changing antennas was a nuisance. I soon had more feedlines than the ATU could handle, plus control cables. Two feedlines connected to a manual ATU that had a 3-position antenna switch, so an extra connector was available for a dummy load.Īfter a bad case of Antenna Fever, new HF antennas appeared on my roof, and new cables snaked into the shack. My Antennasįor several years I operated on seven bands with only two antennas. My shack was nearly as scary as this one. I found that building my own was a fun and inexpensive DIY project and resulted in much more enjoyable operation.įigure 1. Antenna switches and relays are a popular accessory, with many variations are available both “plug and play” and for the homebrew builder. ![]() Soon your shack might resemble the one below, and changing bands and antennas becomes an annoying chore.įortunately, this is a simple problem with simple solutions. As more antennas are added, additional cables snake in toward the operating desk. When we put up the first antenna, a single coax cable enters the shack and simply connects to the new rig. Hams sometimes say, “You can never have too many radios,” but for some that wish applies even more to antennas. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |